Can’t seem to find the troubleshooting section, so hope no one gets offended by posting my question.
I ordered an S2+ 7135*8 from Simon, for a small charge he was going flash the new biscotti firmware.
He didnt confirm if he did or not but I assume he did ship it with new firmware.
If I understand correctly old firmware has 3 or 5 modes.
As far as I could figure out \my S2+ has at least the 1st mode coresponding to the 1st mode of the biscotti choices
1. Moon-low-low2-middle-high-strobe-battery check
I cant seem to be able to switch to any other mode. I push 10 or 15 half presses and then
I only get 2 blinks with some other kind of blinky and the Moonlight.
If I shut it off with full click and on, then I get the same mode 1. Moon……Bat check
I was wondering if I am not doing the “half pressees fast enough in order to switch between modes.
I think Tom and TK were discussing that some drivers are over clocked with a fuse that causes similar mode switching issues.
Am I just too slow to operate the switch or is this a common issue ?