Review: ReyLight Ti Lan Proto

It’s up!

Sold out in only a few hours! 220 units.

Aaand it,s gone…
Already sold out at 200 units… i was fortunate enough, very excited, i believe some forum members sell trits?

Had to stay late last night just to get a couple. Glad I did it. :slight_smile:

They should do another batch. I’m sure they can sell another 200 easily. Awesome light.

Just one question. How will the UV light reach the glue as the trits are in the way to where the most glue is

Got a Convoy S2+ UV light specially for this job….

The plain BLF way: use way too much (UV) light.

Kidding, you will be fine, the uv will bounce around enough with all that reflecting surface.

LOL, will do, cheers. That’s why I felt I had the excuse to buy the convoy UV. There’s no scorpios here and I know where my cats tend to piss :smiley: :stuck_out_tongue:

Hi Rey,

Received mine today and installed the trits. Awesome light!

One problem. It shuts down after a couple of seconds when fed on 14500 (tried both unprotected and protected ones). Does that mean my switch is faulty?

Pls try to full click it for several times, if it takes 2-3 clicks to turn the light on, it is a burnt switch.

Thanks. In that case it is a burnt switch, as it takes several clicks to switch on after shutdown.

Sorry for the trouble, will send you a new switch to repalce, ok? pls pm me your shipping address.

Thank you!
PM sent

Awesome. Photo bucket has screwed my images.

:frowning:

Sucks.

Just got one from the last Mass Drop…very nice light!

Nice 12 trits!

Looks like they increased the slots on the Rev 3…

16!!!

12 around tail + 1 on the switch + 3 around the bezel

Want one of these bad.