Was there an updated rendering anywhere buried in the thread?
If not, based on the original rendering in post one, the tail button is around 2mm thick. That would require a person modding the light to take quite a bit of care cutting the slot for a 6mm x 1.5mm tritium vial to sit flush without breaking through.
The thick part of the tailcap surrounding the button is about 4mm x 4.5mm, so that’s a potential location.
The shoulders on either end of the body tube are about 2.5mm x 3mm.
Ok. I’ll just get trit optics then. Thanks for the info.
Toykeeper’s info about the driver (with the upgraded 7135 chips)!just blows me away. This is shaping up to be amazing. I’m putting my money where my mouth is too, I’m signned up for three!
Hi, I'm listed as being down for four (4) lights, but I only asked for two (2). I've only ever made one request post for two (2). See my history, it's pretty short.
(Not sure what happened. I had to double-check this to make sure I wasn't losing my mind. )
So… Opened the 200+ new post, and accidentally closed it, and then lost track where I left off.
Read the 5 or so newest pages.
Was there a decision on anodizing? How about emitter and temp? Or at least what emitter and temp was most voted for?
Sorry, try to avoid these types of posts, but made a stupid mistake of putting off catching up on the thread and allowing 200+ posts to go by, and closed it by accident when I did get around to checking it…