Sorry if that has been asked before, haven’t seen anything on the last few pages of this thread.
Any info on when you get new stock of the XP16?
Since my order contains some I am thinking about adding two 219C 5700k presoldered on XP16.
Can’t order that using the shop tho since the XP16 are listed as out of stock.
That is awesome.
Can you add two 219C 5700k presoldered on XP16 to my order please?
If I did the math right that would be 2 x 5.85$ = 11,7$.
Question on how to handle payment remains. Should I wait till you put them up in the shop again or another paypal payment?
- The rest of non XP16 orders dropped at the post office today. The tracking numbers will follow tomorrow.
- XP16 orders processing will start tomorrow (received the XP16 from Hank yesterday)
Note: all soldered orders packed in wooden box, that’s why it takes longer than usual. I just want to make sure all LEDs safe and secured throughout the journey.
I said they’re all (non XP16 orders) dropped in the post office today. That means I just need to get the tracking numbers tomorrow when I ship another shipment. Yours already there. It takes time for the officer to process all those packages. I usually don’t want to wait for an hour, better to just get the receipt the day after.
When you have too many used crates and not willing to share with the swarming termites…. I’m not a cheapo, I just love recycling.
I remember sending Jensen567 his order in a (cleaned) sardine can :laughing:
@Maukka: Please check your post office. Your and _ The _ packet already sitting in Finland post office. They said you asked them not to deliver the packet yet. You only have 14 days and the packet will be destroyed.
All orders except those with additional special request, shipped today.
Finally, 65 0f 68 orders are done, shipped!
Sorry for being very slow. I had to keep both this GB and the store orders process flowing. Those of you made last minute changes were queued back behind to keep it FIFO. This was a bad decision and timing, (GB + new product launch) too many things going on. I learnt something. Some might think those wood packings are way overkill, they’re not. Shipping soldered LEDs + MCPCBs is trickier (especially those 20+ mm) than bare LED/MCPCB. I rather get it done overly packed than handling/filing complaints afterwards. After all of these I think it’s time to find an assistant.
So, I thank you all for the patience. Enjoy your last 219Bs!! :partying_face: