Interested
How this gasket work?
Is not close to led.
And same for xp-l and white flat?
Interested!
Thanks Hank
Interested
Ill take one.
Very interested
Very interested, but I must say a regulated 5A mode would be nice to have!
I’d buy one…
I read through this thread and I looked up the data sheet for this led, but couldn’t find any mention of color temperature anywhere. Does anyone know what CCT these new leds come in? I’m partial to 4000k and below, personally. I realize I’m in the minority with that preference.
I would love to exchange my currency for your goods/services (I’ll take one)
Like a few others this is the tipping point that would push me into getting a 1S
yes yes andYES!! I will buy at least 2. (only if they are 18650)
Interested
D1s+….In
21700…in again
well, it appears that the change of emitter is a hit.
Whether you want to make an even bigger leap by changing battery(21700) is up to you.
It would cement your place as innovating further development of the flashlight.
As opposed to to incrementally milking previous versions.
Whatever, you have my attention.
Carry on
Interested
It depends on the bin of the LED but…
Thank you for translating those charts for me.
very interested
Agro, a lot of the industry doesn’t like change, they’re used to hiding imperfections behind sandblasting. To take the parts straight from the CNC to the ano bath will show the machine marks from the tooling and while some of us like that the industry is afraid it will be seen as ugly or unfinished by the consumer market at large. So on the few occasions we have had success it has been in limited runs. I’m ok with that, a serial numbered limited run of 100, or 300, would be great. If they saw a quick sell out then they might be interested in taking it further, maybe a second run of 500 or 1000, who knows…
One thing to consider is that they mass produce these for the best “bang for the buck”. If they were to machine for a raw finish they would probably need to slow the speed, and possibly change the tool and tool path.