Sofirn SP10 Pro (AA/14500/Andúril 2) - now available!

Definitely interested

Tbh from my sofirn lights, the Sp10 is my least favorite. The output is extremely low. Specially compared to the tool AA and Wuben E05

Attiny MCU and AA Voltage wont work without a separate boost powering the MCU, which would make likely a way too high standby drain
not sure how the original driver handles this

they may write a firmware close to Anduril on another MCU, but it wont be any real Arnduril

Maybe 14500 only?

Definitely interested.

Particularly if it can be done with minimal standby/parasitic drain.

Here we go again… AA won’t happen with Andruil, like it didn’t with the Micro GT.
It’s a shame, because AA compatibility is a good thing, but hey if you’re a flashaolic you have some 14500 laying around, no ?

Interested

Interested!

interested

Yes, especially clear anodized

Please take my money

Very interested.

interested

Interested in 1 even if it’s 14500 only but if they manage to get it to run Anduril from 1 AA NiMH I’ll be in for 3-4!

The micro gt was so disappointing I didn’t even buy 1. Whatever ends up happening I hope they don’t list AA in the specs / manual only to change it last minute…

Interested!

If it had AA and 14500 compatibility that’d be great. Though I understand it would be difficult to get AA compatibility for anduril.

Also 4,000K color temp would be awesome, given a high CRI.

And grey anodized special color would be cool too.

Maybe an OP reflector instead of smooth too?

i’ll take 1

Interested! I’m hopeful for high CRI 3500k-4500k with Anduril.
14500 is fine with me.

Edit: Interest withdrawn.

I want one

Interested