Reflector revised: ReyLight Pineapple Brass 14500/AA Flashlight, Nichia 219C 4000K

I like the clip, the one which secured by thread, not just attached on to the body.
Time to activate my piggy bank!

Everything is going well.

Good to hear! Looking forward to the purchase thread… :beer:

It’s looking good!

Can we buy extra drivers too? It would be so helpful.

I love copper and brass

You have my interest !

Proto done, pls check the 1st post.

It looks real nice! How long until the production model?

Looks great! Should be a winner….

Both models look very nice.

What size driver and emitter board will it take?

Nice one RayLight Brassy! :+1:

I’ll take it in copper if it’s reasonably priced (like $50). No interest in Brass or Damascus for $500.

I like the brass prototype, would be interested in a copper version… The Damascus one has flat spots in the tube for logos but it could look out of place if there’s no engraving. I think a knurling or tube pattern will suit it better.

14.6mm driver, 10.5mm star.

The flat spots don’t look good on brass, but I think it will looks great with dama paterns.

First thought is 0.2-3-25-100 lumens on Nichia, but we just found that 0.2lm is barely noticeable. pictures below:

Those modes sound almost perfect, though I’d suggest making the two middle modes slightly higher. Like, 0.2 lm / 5 lm / 32 lm / 100 lm.

How bright was the room when those pictures were taken? A 0.2 lm mode is only for use in very very dark places… It’s fairly common, when someone turns on a light in moon mode during the day, that they won’t realize it’s on without pointing it at their face.

Thanks!

I’m always looking for nice small hosts which can be modded easily, and this sounds promising. :slight_smile:

outer size: 20.5*91mm (this might change)