This is going to be a thread on my L6 just because it’s gone through so many changes I can’t keep track. Lol
First up is amp draw measurements with the stock driver and various resistors.
I received my new Uni-T UT210E so my current measurements will be in line with others here. I used a 6” length of 10 gauge wire on the tail cap. I measured both the Liitokala and KeepPower 5200 protected cells. Emitter was the xhp70. I only tested each for maybe 5 seconds so I could do a lot of tests without …
Halfway down the page this guy has a YouTube for a light I’d like to have. It seems to be direct drive, has led under the switch, ramping with blink for turbo, memory, momentary on the tail switch.
Where can I find this?
mattlward
July 18, 2017, 12:20pm
2
I think you would have to build it. That is not the stock driver or firmware. Have you pm’ed the owner yet?
Well I think he built it for himself.
I can build a flashlight, have done it before but i thought maybe someone could pm me about making one?
Lowtech
July 18, 2017, 1:10pm
4
Lexel here on blf makes the TA driver for L6.