Can someone guild me how to do the thermal calibration for the Anduril

[sahala]

I have flashed the Anduril into the D4S, but had no idea how to do the thermal calibration and set the thermal limit.
It says:
Thermal cfg (4 clicks)

1. Current temperature (click N time for N deg C)
2. Temperature limit (Click N time for 30C+N)

What does it mean, when to click 4 time? Can someone help me?
Thanks in advance.

[sahala]

@Adhara

Let light sit for some time - until it’s acclimated to room temperature.

1. Get a reliable temperature for the room.
2. Enter thermal config, you already know how to do that.
3. First time light starts a “fluttering” dim flash, click N times for N degree C room temperature.
4. Wait, light will indicate second step when fluttering stops, then starts for the second time.
5. Enter the temperature limit with clicks, you already know how to do that.

If you then test it and are not happy with results in hand, just wait in the steps until the second fluttering starts to change temperature limit.

Thank you very much for your help, for the 3 (Enter thermal config), I do not know how to do that, would you please explain it a bit more?

[kikkoman]

@Adhara

5. Enter the temperature limit with clicks, you already know how to do that.

Limit is 30°C + N clicks, unlike in the first step

[kikkoman]

@Adhara

@kikkoman

@Adhara

5. Enter the temperature limit with clicks, you already know how to do that.

Limit is 30°C + N clicks, unlike in the first step

Yes, and the OP clearly knows that already, as seen in the initial post…

Ahh…uhh… yup :person_facepalming: