TK's Emisar D18 review -- 3x18650 photon grenade

277 posts / 0 new
Last post

Pages

CM2010
Offline
Last seen: 9 hours 7 min ago
Joined: 07/19/2012 - 05:48
Posts: 613

Is Hanks website compromised in any way?

I get this warning from Malwarebytes:

Quote:
Website blocked due to a Trojan
Your Malwarebytes Premium blocked this website because it may contain a Trojan.

We strongly recommend you do not continue.

Kevin Z
Offline
Last seen: 2 months 1 week ago
Joined: 10/08/2019 - 19:46
Posts: 296

CM2010 wrote:
Is Hanks website compromised in any way?

I get this warning from Malwarebytes:

Quote:
Website blocked due to a Trojan
Your Malwarebytes Premium blocked this website because it may contain a Trojan.

We strongly recommend you do not continue.


It’s infected with a virus , oh my god ,it’s now spreading into the internet , run for your lives I tell ya.
ToyKeeper
ToyKeeper's picture
Offline
Last seen: 2 hours 40 min ago
Joined: 01/12/2013 - 14:40
Posts: 10310
Location: (469219) 2016 HO3
CM2010 wrote:
Is Hanks website compromised in any way?

If I understand correctly, there was a false positive a while back, but it was fixed… and some antivirus systems still list it. But I’d suggest looking in Hank’s thread or asking him directly if you want more details.

lawallac
lawallac's picture
Offline
Last seen: 3 hours 26 min ago
Joined: 01/04/2012 - 15:31
Posts: 444
Location: WI

All W1 Red Osram CSLNM1.23

nick779
nick779's picture
Offline
Last seen: 1 day 16 hours ago
Joined: 03/09/2018 - 15:46
Posts: 379
Location: Pittsburgh, PA

Are you all just solder blobing higher drain cells or where are you sourcing them? Ive only really been able to consistently find button top 30Qs in the US but maybe im looking in the wrong place.

ToyKeeper
ToyKeeper's picture
Offline
Last seen: 2 hours 40 min ago
Joined: 01/12/2013 - 14:40
Posts: 10310
Location: (469219) 2016 HO3

Not sure about anyone else, but I generally just solder-blob some flat-top cells if I want to use them in a light with a contact ring, like the D18.

Usually I add a blob to the top, and then gently file it down a little bit to make the surface more flat instead of rounded. This should increase the contact surface area a bit, and might slightly reduce wear on the contact ring.

Pages