A few lights + chargers, some modded.

10 posts / 0 new
Last post
contactcr
Offline
Last seen: 2 hours 38 min ago
Joined: 05/19/2017 - 18:52
Posts: 1706
Location: US
A few lights + chargers, some modded.

Shipping is an extra $8 and will be USPS Priority Flat rate (tracked+insured). If you buy multiple lights only 1 shipping charge of course.


Miboxer C2-3000 charger. Excellent condition, supports 21700 batteries. Charges at 1.5Amps x 2 = 3A total.

$15 + shipping


Xtar PB2. Only fits flat top non-protected 18650’s.

$12 + shipping


Jaxman E2L Grayish blue

Right now it’s set up with TA FET+N+1 driver, bistro firmware, bypassed tail spring, SST-20 3000K LEDs, frosted narrow optic, clear switch boot (I have blue and black too). 18650 tube only.

$OLD + shipping



$OLD + shipping

Sofirn Q8 but with Anduril firmware and an AR coated lens from Kaidomain. It is in great condition and probably only used for 20 minutes total.

-Here is an Amazon link for details about the light: https://www.amazon.com/dp/B07GR2HM2Y -

-Here is the firmware details: http://toykeeper.net/torches/fsm/anduril-ui.png -


Nightwatch NS22 “Seeker” which has been modded with a Osram White Flat 1mm2 thrower LED. Bypassed springs, new centering ring. Will include a spare AR coated lens. I had to raise the MCPCB up so there is a very small gap where the bezel doesn’t screw completely on. It comes with an 18650 tube and 21700 tube. The throw is just a little bit more than a fully modded C8 in a slightly smaller lens and much better efficiency/run time.

$OLD + shipping

Edited by: contactcr on 05/15/2019 - 17:33
contactcr
Offline
Last seen: 2 hours 38 min ago
Joined: 05/19/2017 - 18:52
Posts: 1706
Location: US

Bump, added more lights + chargers. Save on shipping and buy more than 1 item

4492011
Offline
Last seen: 1 hour 18 min ago
Joined: 01/23/2019 - 19:39
Posts: 98
Location: USA Michigan

I will take the Ns22 seeker,PM sent

contactcr
Offline
Last seen: 2 hours 38 min ago
Joined: 05/19/2017 - 18:52
Posts: 1706
Location: US

I could bypass the springs on the Q8 for free if that sells it for anyone.

I could probably also change the emitters in the E2L, depending on what I have on hand, if someone is interested.

netprince
Offline
Last seen: 3 days 11 hours ago
Joined: 06/14/2012 - 13:48
Posts: 508
Location: Virginia

What driver is in the E2L? Is it a mountain electronics driver?

contactcr
Offline
Last seen: 2 hours 38 min ago
Joined: 05/19/2017 - 18:52
Posts: 1706
Location: US

Right now it has a TA FET+N+1 from Lexel. I also have a spare MTN FET+1 but as you probably know the TA driver has more regulated levels and is a bit nicer.

Btw, Q8 is sold.

netprince
Offline
Last seen: 3 days 11 hours ago
Joined: 06/14/2012 - 13:48
Posts: 508
Location: Virginia

That e2l is tempting… someone should buy it so I dont have to… Smile

blueb8llz
Offline
Last seen: 1 hour 42 min ago
Joined: 06/02/2012 - 01:16
Posts: 2914
Location: California

The q8 arrived very quickly and in perfect shape. The spring bypass was neatly done as well.
Thanks again!

contactcr
Offline
Last seen: 2 hours 38 min ago
Joined: 05/19/2017 - 18:52
Posts: 1706
Location: US
blueb8llz wrote:
The q8 arrived very quickly and in perfect shape. The spring bypass was neatly done as well. Thanks again!

Glad you like it

contactcr
Offline
Last seen: 2 hours 38 min ago
Joined: 05/19/2017 - 18:52
Posts: 1706
Location: US

modded E2L is sold