Tear Down: Manker E02 / E02H (same as E03H)

Wow. Very interesting design. I’m kind of shocked they would go through the trouble of soldering the led directly to the pill.

I guess the pill (the copper piece) is ‘just another part’ on the back of the PCB, but going through the PCB too.
You can see on the close up there’s a piece of it sticking through between the C1 and R5 marking, to the left of the LED.
You can see a copper circle there.
I should add a picture with an attempt to capture the bit under the LED.
Maybe later.

I have not seen many (any?) tear downs of cheapish AAA lights, but this is impressive.

Thanks, nice pics. Very, very interesting, great aaa flashlight, no doubt!

Awesome! Have you torndown an E01 yet?

Thanks :+1:

I have an Astrolux A01 form the first batch, which is (i think) identical to the Manker E01, including the lovely tinted 219B.
It’s a pretty straight forward construction:
Pill screws in the head, pushes lens and reflector forward.

yep, that is how my Manke E01 went together

So, i was messing around with a small TIR optic, and then i destroyed the XP-G3…
This was a while back actually.
Today i decided to remove the XP-G3 remnants.
I can confirm the copper heat sink protrudes through the PCB, giving the LED a direct thermal path. :+1:
The XP-G3 was badly soldered to the heat sink though, but probably good enough for the <2 Watts power consumption.
I just finished reflowing a 219C 4000K CRI90 onto it.
First the centre pad to the heat sink, and then the + and - traces from the sides.
(had to scrape some masking paint off the PCB first)
…it could still do with a diffuser though…

How did you remove the old Led and reflow the new one? there are many other components around it. I really want to replace mine with a nichia 219 R9080 but still can’t open the light yet

Are the threads of the head of the light glued to the battery tube threads? I can't open my E03H by hand.

How did You manage to screw out the bezel ring?
My E02 is not so well centered and I’d like to justify it. But I cannot remove the bezel ring…
…well, without tool. But I avoid using any metal tool because I am sure it will scratch / dent the ring.

Sorry but this pcb look like amateur project. Solder bulbs and dislocated parts are ugly

Just use a tape to increase the friction, i managed to open mine here (WTS) Nichia 219B R9080 sw45k & 219C 5000k R9050 - #6 by AnhTran

Oh, good idea, I will try it, thanks!

Does the bezel come out easily? It just screws out from the front by pressing against it with some friction? Or is there some glue to soften?
Just got one of these in the mail and there are lots of dust behind the glass

Hi,

Mine had no glue.
Yes, pressing down on a slab of rubber and twist.
I used a bicycle tire inner tube.
Posts above yours mention tape.

I’m sorry i hadn’t read your post earlier.
Now it’s more than 8 months later…
And also, i don’t really remember how i got the old LED off…
It was damaged and i think it came off with a little force, but maybe i put a soldering iron on it…

No glue at all, just friction.
I used self-adhesive masking tape to screw it.

Be careful, there’s no centering washer in the lamp, it is a little difficult to tighten the bezel back with proper emitter centering.

mine does have a centring gasket.
It’s in the bottom left corner of the 2nd picture in the OP.