Ha Ha, All is good my friend, I did understand what you meant and this was really hard to explain without a pic to show what my concern was, I really just wanted people to look at their cells to be safer, it is a weird one.
Just bought 16 new cells with longer posi ends, so I’ll use these from China for what have you.
I’ve been thinking about doing a test with this one cell, like set it up on a nail and have a brick come down and puncture that negative end to see what happens, if nothing then I’ll set it on the band saw and take me a look inside, safety googles, gloves, flak jacket, and helmet at the ready … Ye ha
Neal wearing a UI diagram I made, because of a joke which went a bit too far during the BLF A6 project. I think he was going to send me one, but never did.
Anyway, it must have been a prototype or something, since it seems to be missing some dotted lines.
TK, yes that was supposed to be the proto and the shirts were to be made for sale here at BLF in your honor and the proceeds were to go to you and Neal to the best of my recollection,
He was still at BG then and I think they got word of it and Neal stopped responding and the shirt just fizzled out and we never heard anything about it again, what a bummer it was. You sure hit a home run with that A6 UI.
I spent all night trying to figure out what happened with that one cell of mine and I found out but it’s nearly 5:30 am here and I am beat so I’ll tell you later what I found.
I didn’t know there were two springs and all springs I’ve seen have a 90 degree bend on the end, but not these outer springs so I got a huge slice on my finger and a big bloody Sunday for me, so heading to bed, will explain later about how sharp that spring wire is.
Good night all… :confounded:
There will not be a dedicated warm tint anytime soon. It is about a 50/50 chance of 4000k (which some might consider to be on the warm side) and 5000k at this point.
The neutral tint LED’s should be ordered this week. How long it will take them to get to lumintop is unknown at this time as it will depend on how and where they are ordered.
I have an extra set of Stock BLF GT35 battery carriers (better fit for protected batteries) if someone in the U.S. wants to trade for their GT70 shorty carriers, they are like new…?
@Mark M
Writing the manual and checking if everything is OK would be easier when the writer has a lamp to compare.
But there is never one. Only asking stuff via emails.