For XP-L HI 5A/5D, I would like to mention this Cree code:
XPLAWT-H0-0000-000HU60E5
This is just one bin lower than the 70/75 CRI options of the same CCT, 5A/5D with this 80 CRI option could be nice.
For XP-L HI 3D/4A, I think, one of these codes would be the best:
XPLAWT-H0-0000-000LV20F4
XPLAWT-H0-0000-000LV20E4
This is a bit better with 75 CRI - the 70 CRI options are of the same performance bin, so this could be a nice option.
With these two options above, 3A/3B and 4C tints could be replaced.
Speaking about new flashlights, I think, a single (or double serial) 21700 flashlight with d = 22mm driver would be nice.
Thanks,i will consider to use SST20 or LH351D ,too
S2+ is not a thrower even installing SMO reflector,but the OP reflector can make the light spot even.
5D and 5A is a little redish ,i will try them
i’m ready to launch an new model ,single cell ,XHP50.2
it seems not meet your requirement,I can refer to your request and design an flashlight with side switch and stainless steel bezel and type-C port,
what battery are you ready to use?
I don’t find charging circuits in flashlights useful. Flashlights are bigger and less waterproof. It’s easier to swap a battery and continue using the flashlight.
It appears the BD03 might have an e-switch in the tailcap due to the battery carrier device. Is this the case? If so, we could put a nice driver in this one.
This looks great. 21700 with Type-C recharge will be awesome! Can we request that the driver is separate from the USB C recharge so it can be replaced? I’m sure many people will like to mod this flashlight with spacer and quad emitters.
Also, would be nice if you can come out with a 21700 S2+.