Sorry guys for the delayed shipping.
I recently got a new full time job at this place:
And it delayed shipping by a week.
I’ll start shipping again starting tomorrow.
All orders will be shipped this week.
Recieved your springs and LEDs
happy modifying 
I haven’t kept on top of this thread and whilst there’s no rush, I was just about to check to see if my order had been posted as lots seem to have got theirs, but you beat me to it. Good to hear your new job is going well and thanks for the update about LED’s.
Russ
Just received mine in the mail. Thanks so much.
Got my LEDs as well. All tested and working. Thanks!
Sounds like the ideal place to work for a LED addict! Congratulations!
Not really…
I’ll talk about it later today for why it’s a good job, but not a great job from someone who comes from BLF.
Hello,
I want to purchase
–6pcs large BeCu spring
–6pcs small BeCu spring
-If any are still avalible: 3, or up to 8 SST-20 FD2 could I pay $3.00 each for them?
@Everybody, the shipping deadline has been set at Tuesday next week. That means EVERY ORDER WILL BE SHIPPED BY TUESDAY MORNING AT THE WORST.
@likevvii, you’ll have to wait until Wednesday next week to see if there is any remaining stock for the LEDs.
Ok thanks!
My order came in today. Package is beyond the capacity of even USPS to mess up. (probably should not say that, they never cease to amaze me with their ability to destroy my packages)
All in order, Thanks again BlueSwordM!
Finally got around to throwing together a convoy S2+ with triple SST-20s and I’m super happy with them. They really are gorgeous. Best looking SST-20s I’ve seen yet and just a hair behind dogfarts for me as far as preference goes. Thanks again BlueSwordM!
What’s with the Samsung LH351D pejoratively called “dogfarts”?
SPHWHTL3DA0GF4RTS6. That’s the part number.
HaHa! :laughing:
I would have never seen that, if you hadn’t pointed it out!
It’s not kind to this emitter.
Granted Samsung didn’t give it a “nifty” name as Cree does, but to dig and construe a less than flattening surname from the part number would not be in my vocabulary. Most probably Pwsmith didn’t coin this, so not to take personally.
just FYI I built a S2+ with single sided LD-A4 driver (it has large spring pad) and used gen 2 large springs on both ends. Flat tops fit perfectly and the elasticity was not an issue
Some lowbrow clowns on /r/flashlight are the ones who started calling it “dogfarts”. 
It’s an LED… It’s not your girlfriend, I don’t think a stupid nickname is going to hurt it’s feelings.
Is Digikey the best US based source for them now?
Their price and shipping is lower than arrow’s super high $12.99 shipping.
Just a word of caution but one of my LEDs died (broken bond wires) when I dropped the optic into my H03 from a height of about 1 cm. They seem to be quite fragile. The ones on my triple board have been fine.