I haven’t kept on top of this thread and whilst there’s no rush, I was just about to check to see if my order had been posted as lots seem to have got theirs, but you beat me to it. Good to hear your new job is going well and thanks for the update about LED’s.
I want to purchase
–6pcs large BeCu spring
–6pcs small BeCu spring
-If any are still avalible: 3, or up to 8 SST-20 FD2 could I pay $3.00 each for them?
My order came in today. Package is beyond the capacity of even USPS to mess up. (probably should not say that, they never cease to amaze me with their ability to destroy my packages)
Finally got around to throwing together a convoy S2+ with triple SST-20s and I’m super happy with them. They really are gorgeous. Best looking SST-20s I’ve seen yet and just a hair behind dogfarts for me as far as preference goes. Thanks again BlueSwordM!
It’s not kind to this emitter.
Granted Samsung didn’t give it a “nifty” name as Cree does, but to dig and construe a less than flattening surname from the part number would not be in my vocabulary. Most probably Pwsmith didn’t coin this, so not to take personally.
just FYI I built a S2+ with single sided LD-A4 driver (it has large spring pad) and used gen 2 large springs on both ends. Flat tops fit perfectly and the elasticity was not an issue
Just a word of caution but one of my LEDs died (broken bond wires) when I dropped the optic into my H03 from a height of about 1 cm. They seem to be quite fragile. The ones on my triple board have been fine.