MF01 Mini / MT07- Mod/Upgrade - Copper Heatsink Cover Plate

Flashlight Modding and DIY Parts
224

Hallöchen, hätte gerne noch ein Drittes ! Danke, LitN

225

Payment sent and PM my shipping address. Thank you!

226

Ich würde auch gerne eine Platte nehmen.
Besten Dank und Grüße

I would also like to take one plate.
Best regards

Felurian

227

Please change my message from one to two cooper cover plates. Thank you!!

228

Interest in one.

229

Interested for 1

230

I will make the video together with the MF01 mini review soon. Sorry for delays but A lot of collegues went to holiday around christmas so I had to go to work a few extra days. After that I got flu and just came out of it. I don’t had a complete healthy week since start of October. I don’t forget it. Or if anybody has questions Just feel free to ask and I will answer if I can. You can send PM also to notice me if I miss a question. Sometimes I doesn’t get emails of new posts.

231

INTERESTED!! 1

232

Today i receive four copper plates. Now the Mod begins.
Thank you very much!

233

Danke für die Info.
Looking forward to your feedback, and please pay attenchion to the installation description on post #1.

Thanks Zozz, don’t worry about getting late with the video, health is of course a priority, it’s more important that you are fine.

A short installation video would be very helpful for some, I was thinking of doing it myself, but that’s just not my expertise.

234

It`s done! Four Lights are now better then before.

I follow the very helpful installation description. So it was very easy and quickly done.

The Mod is very worth it! Stays much longer brighter.

Thank you very much :+1:

235

:+1:

236

Thanks for your feedback, nice to hear,enjoy the full potential of the lights.

237

It has arrived, Thanks again man of light.

238

I would like to have 2 pcs. Great idea !

239

I’m interested in the second batch. Please sign me up.

240

For everyone interested, today I updated the post #1 and post #2 with some news on the Status and the 2nd batch.
Please take a look for the latest infos.

241

It works great, done in 15 minutes. :+1:

242

Interest in one

243

Thermal test now done

Test conditions:
driver temp sensor on PCB calibrated
set to 50°C
Full AMC heating at 2.4A

Time lapse x5 almost 5 minutes

I found that stock the Anduril firmware seem to quite regulating after first throttle, it may get into unsafe temperatures
In an assembled light a lot of the heat will be conducted away from battery tube, so the bare AMCs will stay a bit cooler
and the AMC heat spreader will stay quite a lot cooler than in this test

1. tested stock upper left
it seems after first throttle the temperature regulation quits and it heats up to 70°C on PCB

2. Aluminum prototype
lower left

3. production sample copper

middle upper and lower