*BLF LT1 Lantern Project) (updated Nov,17,2020)

Whining noise from the charge regulator chip, I believe.

whats the ATL for the LT1?

LT1 arriving soon. :smiley:

Which Anduril firmware should I update it to?

I have a SOIC8 clip to modify a UT210E…

The LT1 build of Anduril 2?

Most up-to-date build of Anduril 1 is already installed on the LT1?

before flashing, see if there is a feature you want/need on it first?
mine came with SOS, long push from off gives low mode. i’m good :partying_face:

Good point. I’ll only flash it if there’s some bug that was fixed for a feature that I’d use. :beer:

cheers TimMc :beer:

I’m a bit lost with trying to find the project / branch for LT1 and what was changed (checks ToyKeeper’s signature)…

LT1 arrived! The handle is aligned perfectly. :+1:

Thanks DBSAR and Sofirn!

still endlessly waiting for LT1 to arrive at amazon.ca warehouse

I ordered the LT1 kit from amazon.com.au on the 29th of October when there was no stock locally in Australia. It was shipped from China and arrived today.

Can you order the LT1 from amazon.ca and have it shipped from China? No pressure lol. If you don’t need a lantern… It is rather nice :stuck_out_tongue:

there’s not even a listing for LT1 on amazon.ca :weary:

buy it direct then?
https://sofirnlight.com/blf-lt1-lantern-rechargeable-tint-ramping-2700k-5000k-new-version-works-with-your-typec-charger-p0013.html

Thank you DBSAR for creating this gem. Some lights just give you joy and this is one of them. I just keep it on my desk to give that warm tint to my office space in the evenings. Thanks!

I ordered my for Sofirn official store on AliExpress. Took about 8 weeks to arrive (took them 3 weeks to ship). But eventually all is good.

im waiting, they said it will be available on amazon.ca near end of november…im not sure how long ordering from their site will take, anybody have experience? is it faster, slower, or about the same as any other BG/AE orders?

i just ordered a IF25A direct from sofirn. placed the order last sunday, it shipped tuesday.
[edit]back when i still used amazon, my LT1 shipped from china anyway.

ya i can order now, well not LT1, some other lights, and its sold by sofirn, and shipped from china, but if i wait till their stock gets to amazon warehouse, then its fulfilled by amazon, then its much faster.

placing order on sunday and shipping on tuesday sounds a bit slow, all BG and AE orders so far have shipped within 24 hours of me placing order.

Does soldering pads 4 and 5 do anything on rev 5 of the board? They’re connected by a 0 ohm resistor?

Would soldering pads 6 and 7 negatively impact the mixing of NW and WW? Does the moonlight / lowest level become higher?

from what I understand of rev 5 board there are 0 ohm resistors in positions 4 and 5 already. so soldering those pads does nothing

I believe so

[quote=TimMc]
Would soldering pads 6 and 7 negatively impact the mixing of NW and WW?

[quote]
Not if you solder both 6’s and/or both 7’s

If you solder 6 and 7 the lowest level of the light, or moonlight as you referenced, would be somewhat brighter. The amount of current that is consumed by the batteries scales pretty linearly based on the number of channels connected. The lights brightness doesn’t scale linearly, at least as perceived by our eyes.