[WTB/WTT/WTS] Pulsars Classifieds - Farka F8 v5 + X-Drive 1.8a + SoloStove

SS L2m with A001 head. SS L2. SS L2t used. SS 503b

L2x shorty version

SF 2-way pocket clip

UltraFire TH-1300

1x AAAA flashlight. Klarus MiX5 SS preferred, will consider any

Lumintop SD10

Don’t have money at the moment for any of the lights but I didn’t want to say congratulations on the engagement.

A clip like this? It works on Solarforce and Surefire

I hear ya, the anodizing sounds pretty sweet

ok, ok, I’ll take it. You just had to talk me into it!

LOL!! Yeah, I have literally fought back and forth with myself, since the day you listed it.

…ah finally! The endless battle is over, and I prevailed!

Photo of the laser? Does it have a heat sink?

If DD is direct drive that’s not considered a good thing to do with laser diodes. I have killed two diodes from testing them really quick like that.

Yeah, lets just hope you didn’t LED the diode. A lotfof the times when you kill them they still emit a very dim light, like a LED, but they wont lase. DD a LD is a very bad idea and has high risks. A PSU is the proper way to test a diode and Jordan doesn’t send dead diodes so there really is no reason to test the diode once you get it.

No flash is needed. If its over powered then it could A) protect itself or B) just die. I’d suggest finiahing it and keeping it. You only need glasses to burn and use inside. You can use it outside for sky pointing all you want without glasses (just make sure it doesn’t reflect off anything in the sky like wires trees etc……) burning gets old and quick. Only reason I have safety glasses is to show friends what it does and to meter my lasers. Kinda a waste if money since I personally don’t use them to burn anymore

$90 is a real deal. Would sell fast on LPF. DD at that low a voltage shouldn't hurt that diode at all.

I won't part with mine unless I get something more powerful. It's unlike any other tool I have and I will keep it around just in case. Plus, if laws change, acquiring one in the future may turn out to be more difficult and expensive.

Pulsar,

FYI, you can buy the A001 head from Nailbender's site. It's sold with the SS strike bezel, but you can buy the flat SS bezel from his site too.

Gary

A001 head is Type II anodized. Never seen it in stainless. SF bezels come in stainless.

Wasn't aware there was a special-edition all-SS version. Just discovered it on an old CPFMP thread. You might want to expand your search to over there as well. Good luck in your search!

XinTD x3 ww mint condition, spare battery tube - 25 shipped

Farka F8 v5 near mint, very minor anno wear think I still have to box and two bezels - 30 shipped

Bump for the XinTD x3 and Farka F8 v5.

BUMP!

XinTD x3 ww mint condition, spare battery tube - $25 shipped

Farka F8 v5 near mint, very minor anno wear think I still have to box and two bezels - $30 shipped

X-Drive 1.8a buck driver for laser diodes. Prewired with 17mm round contact board. Never used- $25 shipped

Solarforce A001 head - $20 OBO shipped

WTS Post:

https://budgetlightforum.com/t/-/21955#comment-479296

The Solarforce A001 head and bezels are sold pending funds.

Bump!

Surprised no one has hopped on the XinTD x3.

First run with warm white XML2 T3 6A1, 4 mode qlite driver... in like new condition...

Bump