STARTED: GBGB: Stainless steel AAA clicky with a clip (CQG S1 "clone")

Hi the, would efest 10440 work for this light? I have one and it is flat top. Thanks!

Should work fine. Flat top is not a problem because the light has spring also on the driver end.

Ordered NW and CW. Kiitti järkkäämisestä :slight_smile:

Does anyone know that will this take a protected 10440 li-ion? What 10440 have ppl used in these? Need to order a couple from DX if they carry a cell that works on this light.

Thanks the !

Thx Sesgum

Shipped. 8)

My NW shipped, well according to GB it did so only time will tell

unknown00101 wrote:

heggood wrote:
Why does everyone keep posting what and when they order in this thread? Is that a requirement or something from anyone who orders or is that just a symptom of flasholism?

I view it more as a thank you to those involved, and a free bump for a good deal. Then more people get to get in on it.

+1

It's just good manners too. Too often we see some one work on a thread or deal that gets hundreds or thousands of reads, but only a few replies.

Yes, I did. Two NW flashlights and 1 Opus BM-100 battery charger all shipped separately. :slight_smile:

in for 1 NW

Cw and nw are shipped.

Hello Ejected Filament,

The specific verification is for your “first name”, one CS found the first name of this order WW1407070617259002 not match for your order History, so she transferred this order to the “verification channel”, but when she found this, the other order WW1407080615043210 has shipped out passed by another CS since your order’s first name and paypal’s name matched. I’m sorry to make things complicated, and sorry for the delay shipping order, we will improve our system to avoid the same situation, hope you can understand, thanks :slight_smile:

Its all good and thanks for clearing it up. I guess Im glad someone is looking at the orders, not simply an automated routine.

My NW shipped too, now the waiting starts.

I wonder if the clip comes installed?
Reason is because I may never use the clip so removing it if it comes installed will probably damage / scratch it…

The clip is pre-installed. Removing it might cause only very minor scratches. Removed mine a couple of times and the light is still looking good in my eyes. :)

Bugger, good to hear it can handle the removal not too bad though.

I also took the clip off, and on, and off, and again i.i.r.c. without visible damage.

Btw, i just took mine apart by unscrewing the bezel, and i find a nice glass lens, an aluminium reflector, a g.t.i.d. O-ring, a (looks like) teflon washer, XP-E on tiny (8mm?) alu MPCB, and a tiny brass pill with a tiny driver.
A spring pushes the pill forward.

Sorry, didn’t take pictures…

Thanks for confirming my findings. :)

[quote=Jerommel] Sorry, didn't take pictures.. [/quote]

I did (see post #53)

Some measurements:
- pill diameter 10.8mm
- star diameter 7.8mm
- driver diameter 10.1mm
- emitter wires: short (almost stripped them by lifting the driver )
- driver cavity depth 4.0mm (3.0 + 1.0mm PCB)
- pill is solid, quite thin though

Some more photos of the pill: