[WTB/WTT/WTS] Pulsars Classifieds - Farka F8 v5 + X-Drive 1.8a + SoloStove

Pulsar,

FYI, you can buy the A001 head from Nailbender's site. It's sold with the SS strike bezel, but you can buy the flat SS bezel from his site too.

Gary

A001 head is Type II anodized. Never seen it in stainless. SF bezels come in stainless.

Wasn't aware there was a special-edition all-SS version. Just discovered it on an old CPFMP thread. You might want to expand your search to over there as well. Good luck in your search!

XinTD x3 ww mint condition, spare battery tube - 25 shipped

Farka F8 v5 near mint, very minor anno wear think I still have to box and two bezels - 30 shipped

Bump for the XinTD x3 and Farka F8 v5.

BUMP!

XinTD x3 ww mint condition, spare battery tube - $25 shipped

Farka F8 v5 near mint, very minor anno wear think I still have to box and two bezels - $30 shipped

X-Drive 1.8a buck driver for laser diodes. Prewired with 17mm round contact board. Never used- $25 shipped

Solarforce A001 head - $20 OBO shipped

WTS Post:

https://budgetlightforum.com/t/-/21955#comment-479296

The Solarforce A001 head and bezels are sold pending funds.

Bump!

Surprised no one has hopped on the XinTD x3.

First run with warm white XML2 T3 6A1, 4 mode qlite driver... in like new condition...

Bump

Bump!

Why wait on the X3 group buy when you can get an original with t3 6a1 tint, and qlite driverfor the same price shipped from the US?

Added my original Solo Stove to the list. Had it up on Spirit Burner for a while now, but they are mostly into older pressure stoves and other classic stoves. Thought maybe someone here would like to add it to their survival gear for almost half price

May be you should state it IOS version of X3?

I should have. But I have decided to keep it for now.

Bump!!!!!!!

BUMP!!! Make offers I guess... Need some GB $$$$

Just posted these items up on CPFMP... didnt want to but need them gone

Bump!

Solo Stove is sold pending funds on CPFMP

Made an account on laser pointer forums, and listed the X-Drive there. Now I just need to be able to pull myself away from that forum once its sold and not get sucked in.

What size/footprint bare MCPCBs are you looking for? I have quite a pile of them built up...

I should edit that post. To be honest I dont remember what I wanted them for, and dont really need them right now...

BUMP!

Still have these items for sale in the first reply to this thread.

XinTD x3 ww mint condition, spare battery tube. Spare battery tube has one end that is not cut very square but still works

$30 - Shipped CONUS

Farka F8 v5 near mint, very minor anno wear. Think I still have the box and two bezels and other assorted orings and stuff. Lanyard ring not included.

$30 Firm - shipped CONUS

X-Drive 1.8a buck driver for laser diodes. Prewired with 17mm round contact board. Never used. Will not fit the shallow driver cavity in my heat sink. They say these are the best drivers available.

That is the cost of a X-Drive without leads or 17mm round contact board. Just spend $30 on it, need to recoup some funds

$25 - Shipped CONUS