Nice price. But there is a big difference between xpg vs xpg2>>> tint and brightness goes to xpg2.
tint can’t “go to xp-g2”
Tint is a matter of personal preference
Hey, that’s a great deal! Do you have one left?
Still using the one I got from OP a while back. It's a really nice light for the money.
Like I said, nice price. But xpg2 trumps in brightness. Unless of course, like tint preference, you prefer dimmer light
.
Ya, I have sold about 5 or so for the black friday deal so far, and have about 25 left.
Thanks everyone for all the great feedback :)
Nice. 
is intl shipping price the same for more pcs?
Hi Chenko,
Sure I can do that.
Paypal sent for one. Thanks!
Payment sent, thanks for the deal.
Still a few lovelies left
Interesting light, I like the UI. Anyone stuffed an XP-L in one of these yet?
Edit: You weren’t kidding about the lock-tite, the head was a pain in the * to get apart, well worth it though.
I swapped the very thin aluminum MCPCB with a slightly modified Noctigon and a 5A1 XP-G2. Even with the warmer tint I ended up with a 16% increase in output.
Much nicer now.
Paypal Sent
Paypal sent for one.
Thanks.
I so want a couple or three of those to mod with neutral or hi-cri led! How did you disassemble the loc-tite-d head? What diameter PCB fits right in? Ideally I would buy some ready made noctigons just to solder the 2 wires to the board, as I have no modding experience nor time to try reflowing.
WOW! I just read specs and think this is a great deal! If I could, I’d buy two but at the moment I’m in some debt… Vesture, I’ll post here if the funds show up. Thanks for the deal 
I heated the head with a hot air gun, hot enough that I couldn’t hold it for any length of time but could touch it briefly. Put it in a vise and used a large strap wrench. Made a few small marks on the head even though I had it wrapped in heavy rubber.
The original MCPCB is 16mm x roughly 1.0mm but it has a couple of cut outs, you can see what it looks like in this excellent review of the MT21A by the. Slightly different light but the same set-up.
Noctigons are a little thicker, about 1.5mm but work fine.
You could get the emitter of choice pre-mounted and just spend a little time with a file to get it to work.
One more nice thing is the MCPCB is not glued down and has a great centering ring.
Paypal sent for 2pcs! I’m sending you a PM with shipping address. Thanks for the great deal!
Orders shipped
How many do you have left?