The Nitecore P36 but have it modded (technically above my pay grade) so that the last three (three highest) of the 10 steps were higher plus change the temp power cut in point. h and swap the teflon spacer in the head to Copper.
The TN36 xhp70 NW (maybe a few) but pull the top level down a bit (I know blasphmy). I would rather have the jump from the second highest behigher and the highest be lower (run time temp managment reality check). oh and ya it woud need some serious copper thrown in it.
do I also get to have all my reflectors plated in rhodium, hey if women get their rings replated I figure I can get my reflectors done:)
You see, the issue is not money, but the lights we really really want are no longer being made.
I want a brand new Lummi RAW Ti with trits. When it was available I didn’t think that something this size could ever worth $250, but after 5 years with my RAW Al ($130), I realized no light can come close to it in terms of size, output, throw and build quality. I regret not going with the Ti version.
If money was no issue I would buy the best CNC Lathe money can buy and just have you guys send me nice CAD files to feed it, if the design is good it would be 1 light for you and 1 for me, maybe even do design contests and the winner gets his light made…free!
Solid 24K gold custom light built by MRsDNF, would have a platinum bezel and tail cap end, maybe with some diamonds mounted on the head and tail cap. Would pay MRsDNF $20,000 for his labor. Would also have a custom driver built by , probably spend a grand or two on that.
well the problem is money always be an issue for me
any light my money can buy if there is no issue though,heck i even buy the flashlight factory itself J)