How to use drivers that have + and - leads close to driver edge?

Hi,

I was wondering how you all use drivers that have the + and - leads really close to the edge of the driver, e.g., with the EAST-092 drivers:

https://www.fasttech.com/products/0/10001752/1127405-3-7v-5v-5-mode-led-flashlight-direct-drive-driver

both the + and - contact pads and leads are really close to the edge of the board on the emitter side, so when the driver goes into the pill, they can both touch the pill?

I’ve tried putting some Kapton tape over that edge before putting the driver into the pill that didn’t seem to work. It might be that when I did that, the driver was a press-fit and maybe the tape moved…

I’ve also been thinking that maybe I can try cutting/filing a notch in the edge of the pill, but is there a better way?