WTS: a few stock drivers...

Buy / Sell Want to Sell
1

3 factory drivers for sale, all working perfect.

First is a driver out of a TrustFire 3T6, it runs from 1-3 cells and outputs 3 or 6v (1-2 3v emitters in series, 1 6v emitter, 3 3v emitters in parallel), stock drive current. $10 shipped

Next is a stock driver out of a TF-9XT6, it runs up to 9 3v emitters in parallel from 2 or 3 cells in series, it will NOT run 6v emitters. Factory drive current. $10 shipped

Last is the driver from a Fenix P2D, this is true constant current, the 3'rd wire is to sense when the head is grounded against the body, with the head tight it is 2 mode (turbo/strobe), with the head loose its L, M, H, SOS, Beacon. Again factory drive current $10 shipped

Take $5 off 2 or all 3 for $20 if you want them. Guarenteed working or your money back.

2

What is the diameter and height of the Fenix P2D driver?

I may have a project that could use it….
Thanks.

3

The base is 20mm, I’ll measure the height this afternoon for ya.

4

Already too big for my plan at 20mm.

Looking at that grid you photographed on had me thinking I should know the diameter…
So the grid is about 5mm per div?

Thanks, maybe I will come up with another use.

5

Well it turns out the diameter is 18.8mm and the height from the top of the PCB to the top of the tallest component on the slave board is 7.7mm.

The grid is 5 per inch.