Where do I solder the electronic switch wires on this driver?

Flashlight Modding and DIY Parts
1

Good evening everyone!

I am replacing the driver on my EagleTac TX25C2 flashlight since I do not like the stock one, Can someone please confirm if this is the right place to solder the electronic switch wires to this 22mm FET driver

Here is a pic of the driver I want to use and the 2 arrows is where I think they should be soldered but confirmation would be greatly appreciated :slight_smile:

Pic from MTN Electronics

Pic where I think the wires for the electronic switch should go

Thanks in advance for your help, :beer:

AlexGT

2

Left arrow for the switch. The right arrow is ground, the 2nd switch wire can go there or any other place that’s easy to get ground.

3

Thanks Halo…! :beer: