I broke my favorite coffee mug right on my bare foot on my kitchen hardwood floor this morning. What a bummer!. Luckily my foot survived because the first part of the coffee mug hit the floor first. Still, my big toe hurts, but thankfully it’s not turning black and blue so far. I hate when I screw up!
It wasn’t today, or yesterday for that matter but recently I inadvertently knocked a capacitor off a Qlite while adding 7135’s. The light still functions but only on 100% so I can’t sell it and no matter how hard I tried I couldn’t solder it back on.
I also recently smoked a FET driver by shorting an led wire against the reflector while trying to focus the emitter. Immediately bought some kapton tape. Not going to let that happen again.
It’s funny because I edited my post. Rearranged my sentences. Sometime I type what’s in my head not realizing it would be better I said this before that. Oh well, it is what it is …lol!
I was just about to fill my mug when I lamed out. That said, I’ve had bad luck with my feet. I broke my right foot 2 years ago doing something stupid. And back in the 70’s, I jumped off a roof and fractured my left heal because I got too stoned to climb down the same way I got up… Yep, I’m a piece of work…lol
I dropped the tailcap. The PCB is glue-ed in. It’s being taken care of though. I can’t say if it’s a tailcap misalignment issue or another problem. I’ll figure it out in a few days- but I will say… Illumn is amazing.
Just broke the XM-L2 in my Convoy C8. I had dedomed it a few months ago but figured I could make it look a little better and lift off a sliver of silicone that was left behind. I broke both bond wires :weary: