Voltages for connecting ds18b20 to Edison breakout board

1 post / 0 new
mozobata
Offline
Last seen: 4 years 3 months ago
Joined: 07/20/2017 - 05:14
Posts: 1
Location: USA
Voltages for connecting ds18b20 to Edison breakout board

It appears that the upm library provides support for reading temperatures from a ds18b20 on an Edison via uart. They also provide this hookup diagram. However, it looks like the ds18b20 can only operate at 5V while the UART TX and RX on the breakout board are at 1.8V (table 28). This upm diagram seems to suggest they should be directly connected though. I am hesitant to try it for fear of damaging the board or module.

Do I need to step the voltage up and down between the Edison uart and a 1-Wire bus?

If so, what would be the appropriate way to do that?