Carlco 10622 optics has clearance for XP-L2 leds?

6 posts / 0 new
Last post
ZozzV6
ZozzV6's picture
Offline
Last seen: 1 week 2 days ago
Joined: 03/24/2016 - 12:19
Posts: 2425
Location: Near to my soldering iron.
Carlco 10622 optics has clearance for XP-L2 leds?

Hi! does anybody has XP-L2 led and Carlco 10622 quad optics to try if the led fits under the optics? This is used in the Emisar D4. And I have a plan to build an Eagle Eye X6R with quad XP-L2s which is with a good fet driver with Narsil or Andúril firmware I will hope puts out 6-8000 lumens Big Smile
But I don’t have the optics so I want to know if it fits before I order 4x XP-L2s.
Thank you!

Agro
Agro's picture
Offline
Last seen: 3 weeks 3 days ago
Joined: 05/14/2017 - 11:16
Posts: 6801
Location: Ślōnsk

According to RMM, they fit 10507, so probably 10622 as well. Also, I think djozz built a D4 with XP-L2. He went after CRI, so no dedome. It is somewhere in WDYMT.

djozz
djozz's picture
Offline
Last seen: 1 hour 8 min ago
Joined: 09/07/2012 - 17:04
Posts: 17864
Location: Amsterdam

yes I did, it fits alright. I just did not like the tint of the 90CRI XP-L2 so I may swap them out again. The fit and the beam were fine.

Jack Kellar
Jack Kellar's picture
Offline
Last seen: 13 hours 4 min ago
Joined: 03/09/2014 - 14:21
Posts: 2101
Location: Throwing bolts at anomalies

djozz wrote:
yes I did, it fits alright. I just did not like the tint of the 90CRI XP-L2 so I may swap them out again. The fit and the beam were fine.

Is there a single XP-L2 that has a pleasant tint?

ZozzV6
ZozzV6's picture
Offline
Last seen: 1 week 2 days ago
Joined: 03/24/2016 - 12:19
Posts: 2425
Location: Near to my soldering iron.

Thank you everyone!
Then I start to collect parts for the quad XP-L2 Eagle eye X6R with Some Fet+1×7135 driver with Indicator led and Narsil or Andúril firmware. Maybe I finish it for christmas Smile

djozz
djozz's picture
Offline
Last seen: 1 hour 8 min ago
Joined: 09/07/2012 - 17:04
Posts: 17864
Location: Amsterdam

Jack Kellar wrote:
djozz wrote:
yes I did, it fits alright. I just did not like the tint of the 90CRI XP-L2 so I may swap them out again. The fit and the beam were fine.

Is there a single XP-L2 that has a pleasant tint?

Yes there is actually: the current batch of 4000K 80CRI from Mouser has a great tint (slightly yellow and rosy), but don’t fall for the 4000K 90CRI one, I’m sure that the CRI is better but the tint is green.