1050ma kaidomain driver NANJG 10 information needed

3 posts / 0 new
Last post
Budgeteer
Budgeteer's picture
Offline
Last seen: 8 years 3 months ago
Joined: 08/24/2010 - 02:19
Posts: 3087
Location: Slovenia (EU)
1050ma kaidomain driver NANJG 10 information needed

Hello.

I was looking at this:

http://www.kaidomain.com/ProductDetails.aspx?ProductId=9606

There is some mention about hi,med,lo modes.

I don't see any pwm chip on it i guess it's all BS?

kragmutt wrote:

They're gonna send you a green redcat with a black LED.

Vectrex
Vectrex's picture
Offline
Last seen: 1 year 1 week ago
Joined: 05/01/2010 - 15:39
Posts: 2778
Location: Gemany (according to my Black Cat)

I guess it's single mode and with an additional "resistor switch" you can activate 1,2 or 3 AMC7135 , which would result in 350 mA, 700 mA or 1050 mA. The same board with 2 AMC7135 (700 mA) is advertised as high/low capable.

Budgeteer
Budgeteer's picture
Offline
Last seen: 8 years 3 months ago
Joined: 08/24/2010 - 02:19
Posts: 3087
Location: Slovenia (EU)

Thanks, ill get  5 pack of nanjg ak-47 instead.

kragmutt wrote:

They're gonna send you a green redcat with a black LED.