Another tool AAA upgrade

kludge · 2018-03-24T02:33:26.000Z

I wanted another mini hand warmer that takes 10440s without damaging the little boost driver. Put a 21C 4k in a copper tool (thanks for the suggestions)
As expected it all works great from mtnelectronics, and fits nicely.

Nicha 219C 4000k on 10mm copper sinkpad
11mm FET with guppydrv

A lot thicker

ISO 50 - S 1/60
forgot the mode, I think medium

max (the low iso is not doing justice, its brighter than those knock-off xmls)

X80 turbo for comparison :smiling_imp:

This is close to what it looks like to the eye.

CRX · 2018-03-24T02:55:44.000Z

Pretty close to the X80 now :+1:

lumenzilla · 2018-03-24T07:57:24.000Z

That;s nice.
Can you advise where to buy the driver?

Dutcheee · 2018-03-24T13:28:40.000Z

Nice job, the tools are nice lights when modded! Copper should spread the heat nicely I suppose.

If you sand down the front of the tube, you can screw the head down to the O ring. Don’t take of too much, or the elec. connection to the tube can become an issue.
Or you can sand down the sinkpad a little.

Or enjoy it as is :+1:

kludge · 2018-03-24T19:18:09.000Z

lumenzilla:

That;s nice.
Can you advise where to buy the driver?

mtnelectronics

The battery doesn’t last long on high, but it is impressive for its size. Thankfully the driver auto dims if voltage is low.