12

I have an “older” wizard pro v3. Double clicking while on will switch me between the firefly and standard modes, triple clicking gets me to the two turbo modes.

While on in each subgroup, holding the button cycles through 3 preset brightnesses per subgroup, except in turbo there are only 2.

A long hold from off defaults the lowest firefly, and starts ramping through all the groups.

A quad click from off gets me into strobe and beacon modes subset, and holding cycles that subset.

Here’s a text visual:

From OFF:
1 click = last mode used.
2 click = subgroup med
3 click = turbo group
4 click = blinkers subgroup.
Hold = ramping through subgroup low, med, turbo.

From ON:
1 click = off.
2 click = swap between subgroup low and med
3 click = turbo group
4 click = blinker subgroup
Hold = brightness cycle in respective subgroup.

If button is orange or red, med and turbo subgroups probably unavailable due to protection circuit, or only highest available current/brightness used.

If only one mode available, you might’ve left it in sub freezing temps too long. My wiz pro v3 did NOT like sub 20f temps, the switch stopped responding until I let it warm up.

1 Thank