ATTN Lumintop Tool Ti users

[jon_slider]

Anyone tried that light on 10440?

Yes
You are better off using the Copper Tool if LiIon is your goal

*New* Lumintop Titanium Tool

“I discovered that when the Lumintop Ti Tool tail is used on a Maratac Cu or Lumintop Copper Tool with a 10440, it limits to one high mode - so the e-tail from the Lumintop Ti Tool is the culprit.”

*New* Lumintop Titanium Tool

“it appears my Lumintop Tool Ti e-tail operates with all three modes (albeit a bit erratically?) using li-ion, IF they are at ~3.8 Volts or below.”