Can white flat 2mm LEDs damage 7135s?

Marc_E · 2018-12-17T00:44:06.000Z

From another thread:

Hoop:

Marc E:

djozz:

Hoop:

…I’ve only tried with two different generic nanjg drivers so far but the 2mm white flat didn’t light up at all with those.

My mini-GT driver seems to have lost the 7135 part of the ramping after I tried the 2mm2 White Flat (it is still gone with the new led, a dedomed XP-G2). It seems to make little sense if the White Flat with its low voltage was the cause of the damage, but after what you noticed with the NANJG driver I tought it’d be relevant to mention here.

Hoop, do your nanjg drivers still work?

Both seem dead. Neither work with XP-L HI. They were new/untested prior to this test. Not sure if either had E-switch firmware but I doubt it.

Does anybody else have experience of using a white flat 2mm with a 7135 based driver?

BlueSwordM · 2018-12-17T00:51:38.000Z

No, they can’t damage 7135 linear regulators.

Otherwise, low VF LEDs like the Nichia 219C 90CRI and XP L2s LEDs would actually damage them too.

Probably just a coincidence, hopefully.

djozz · 2018-12-17T14:35:41.000Z

I have even a 1.8V infrared led running succesfully on a 8x7135 driver (a sk68 mod from many years ago), although I made sure the chips had a very good heat path.

Jerommel · 2018-12-17T17:13:18.000Z

I run a 219C on a single 7135 in a 14500 headlamp.
So that’s a large voltage drop, but not a problem.

djozz · 2018-12-17T22:44:16.000Z

I just succesfully repaired my mini-GT driver by replacing the 7135 chip, the ramping is fully restored now. So it was indeed a defective 7135 what was going on. But this still does not prove that the 2mm2 White Flat did this.

Marc_E · 2019-04-25T21:37:50.000Z

Bit late but i finally sorted out space to set up a soldering iron so i dug out a P60 module running a 6x7135 driver, tested it worked with the installed XM-L2, swapped the XM-L2 for a 2mm flat white and…
it works fine
So looks like the 7135 failures were an unfortunate co-incidence.