cfy7
January 16, 2016, 2:40pm
1
I’ve put Mtn dad’s together, using a soldering iron so they’re not perfect good enough…
I just put one together and its in a s2+ with a triple wired in parallel.
The low voltage protection keeps kicking in and dimming the light, I’ve got a unprotected fully charged Panasonic 18650bd powering it.
What’d I mess up?
This is the driver I built for it….http://www.mtnelectronics.com/index.php?route=product/product&path=25_123&product_id=431
DEL
January 16, 2016, 2:48pm
2
Make sure the two resistors are in the correct locations (not swapped around) and well soldered. The lower value resistor should have one terminal going to the ground ring track.
cfy7
January 16, 2016, 3:48pm
3
There was a tiny little solder blob going from d1 to c1, I think it’s working now. Thanks!
Edit- Yup, it’s working. Thanks Del. Stupid bright triple s2+