How to charge a laptop battery using accucel 6

Hello everyone,
I had a short on my laptop power supply and now the internal power supply on the motherboard don’t work.
The computer work fine using the battery only.
I would like to charge my laptop battery using my accucel 6 until i buy a replacement.
I had to jump 2 connector on the battery to get power from + and - but it now show 8.2 V
It is a 6 cell so 3 kit of 2 cell together (10.8V)

But when i try to charge it it say balance connect error

Is there a way to charge it ?
Can i use Pb charge with 10V (5P) ? If yes, what A would you suggest?

Thank you

David

iirc the balance taps are not in the connector.
treat it as 3s and disable the balancing.use just the 2 main leads.

That’s what i tried, but no matter if i choose charge or balance charge, i still get the same error message.

i just charged a dell m6500 pack with only a jumper to - and the + and - leads to the triton.
it took a very long time to complete its charge at 1a.
get this.the laptop refused to even talk to it till i charged it with the setup i described.
now it has a wear level of 98%!
damm near new!
it was given up for dead when my neighbor was quoted 250.00 for a new pack.
i got it for transferring her data to a new laptop.
i wonder if there is a flaw in the communication protocol that didnt allow the pack to be detected.
so no not all packs need a handshake to charge.