The fact that he was able to cut open a vented cheap 18650 without it catching fire says a lot about these batteries. This personally makes me feel much safer about these things.
And then there is the end where he hooked it up to a 12v battery and then was surprised when it caught on fire quite violently.
Yeah, I have even found some (from DX) that were labeled as protected and had a board on the bottom to make it look like they were protected. But it turns out it was just a metal contact plate...
Anyone else wince/cringe when the hack saw came out? Also, I was pretty shocked to see the rolled up crap in there, anyone got a link to a construction diagram?
Cheers scaru, the paper looking material in the vid makes more sense now, I was screaming “fake!” At my phone as I watched, Mrs gords thinks I’ve lost it…
I don't know, the alkalines are kinda fun... Right now I'm kinda in the mood for a little bit of battery destroying fun. Off to get out an ammo can, a gas mask, and some nice thick wire. :evil:
Hes either brave as f*ck or dumb as f*ck.. that large saw.. the pliers. He doesnt trust the cells because they exploded and still he goes at it with rather heavy equipment. lol.
In my boredom I now have a CR123, A 16650 nimh, and a eneloop all in a dead short. So far none have caught on fire. As for whether they are burning hot, I don't know; I'm to scared to poke them. ;)
A li-ion would probably fail this test and at the very least vent.