o-rings for tr-3t6

LED Flashlights – General Info 18650 Flashlights
1

Hi, my tr-3t6 lost one ring in tailcap, its just broken and I dont know what the correct ring to replace, whats the correct diameter?

the ring in the lens is leaking too, apparently it seems in good condition, but any wather which submerge the light its just flood the reflctor and I have to unscrew the lens to remove before damage the light.

Which store sell these rings?

thaks

2

I have two o’rings at the tail cap and they both measure 20mm ID x 1.5mm thickness. These here should fit fine.

http://www.fasttech.com/products/1607/10001027/1088607-water-tight-o-ring-seal-23mm-20-pack

3

Thanks, I just put these rings in the cart :slight_smile:

and for the head, this rings will fit? http://www.fasttech.com/products/1607/10001027/1208508-water-tight-o-ring-seal-42mm-2-pack

4

You can often find dramatically superior quality o-rings at most descent automotive or hardware stores. Just bring your light with you for sizing and never be stuck with poorly made chinese o-rings ever again.

5

I’m not sure whats in the head. I’ve one hand out off action and cannot unscrew the bezel. If there the right diameter you can get away stretching orings over things they should’t.

6

Ouch! What happened to your hand?

7

I did a bit off damage to my thumb 18 months ago and it has been pretty useless since so decided to try and get it fixed a little better than it was.

8

Here’s to a speedy recovery. I hope it heals quickly. I ripped a tendon in my middle finger several years ago and it took several surgeries before it could withstand the abuse Im accustomed to giving it.

9

Thanks so much MRsDNF and FlashPilot :slight_smile:

The ring of head I find in store near my house and the rings of tail I’ll order too.