P60 Build help?

Posted this in the DIY forum but it may be better here.
Hi all,
Building my own P60 with the KD 8×7135 V2 LED Driver 3040mA 17mm for my L2P.
I want a OP reflector. Where is the best place or places to get all the parts with the recommended reflector. I would need the pill, spring, reflector, isolator, XML-U2 1a or U3 thermal paste etc…

Also looking at the 8xAMC7135 (3.04A) (selectable) Mode Driver from illuminationsupply.com. How is this compared to the KD driver?

TIA
.

Illumination supply has everything you need. That driver is a good one and is very easy to change the modes on.

Drop in: https://illuminationsupply.com/p60-dropin-empty-choice-of-op-or-smo-p-40.html

U2: https://illuminationsupply.com/cree-xml-16mm-round-mcpcb-u2-1a-tint-p-186.html

AA: https://illuminationsupply.com/arctic-alumina-adhesive-5g-set-p-109.html

along with that driver.

If you’re a soldering hero, ignore this advice.

However, if you’re like I was and this is early days soldering tiny stuff, get a spare driver. I killed a few before finally deciding to get a serious-ish soldering equipment. (fwiw, Hakko fx-888; it’s in transit now and I can’t wait!)

I noticed the driver from illuminationsupply.com states w/memory. Anyway to have the modes without memory?