Qlite driver - Negative lead and adjacent 7135 chip bridged with solder?

[WillyD]

Andrew, I had a similar question not too long ago. Member posted a nice pic in this thread which might help.

**Resolved** Need some help on a Nanjig 105c

My C8 started flickering lately, so I pulled the driver and found the issue right away. The positive pad on the driver board has separated or peeled away from the actual board. I put a dab of superglue on it and pressed it down and I’ll try to bridge any gaps if they are broken. But, I don’t think it will hold soldering the positive led wire back on it. Is there any other spot on this driver where I can solder the positive led wire back on? If not I’ll probably just scrap this driver and put a n…