1

i bought a new “gray” (blue) S2+ from BangGood

it seemed to work flawlessly when i first got it on monday. now i struggle to get passed the first brightness.
i short press for less than 0.5 of a sec. will go to the sencond maybe 2 out of 10 times.
battery is at 3.9v

is the timing that finicky with these, or do i have bad firmware/driver?

2

https://www.banggood.com/Gray-Convoy-S2-SST20-LED-Flashlight-18650-Flashlight-Camping-Light-Hunting-Emergency-Lantern-p-1420655.html?ID=566432&cur_warehouse=CN

3

Did u try configuring the biscotti (dont if you havent)?

Also try these steps and clean all contacts

https://www.fenix-store.com/troubleshooting-your-flashlight/

4

thanks, i hadn’t tried choosing yet. i was using the default (1)
contacts seem clean. the light is bright if i use a group that starts with 100%
the light seems to want to either not go to the 2nd setting, or if i’m on the 3rd it goes back to 1.
i know a long click should set it back to 1 but short clicks do it too. very frustrating. :person_facepalming:

5

Retaining rights should be tight

The tail ring in the s2+ should be reverse thread

6

thanks. i checked them, they are both firmly in there.

7

Have u tried a new bat?

If so and nadda then …

Contact simon

He might send u a new driver which youll need a soldering iron for

8

yeah i swapped batteries, same deal. :confused:
i’ll contact Simon then i guess.

thanks everyone.