S2+ Triple 219b build help

Well, I’m not sure if I’m a good helped or not, but I try to do my best (even if not completely accurate all the time :smiley: ) !

Hum, if Richard said that, then he’ll now best, and if you struggled to change the wires in the other drivers, better to leave it that way! ´
Also, in case you decide to use high-drain cells, the thinner wires (along with the rest of the setting) will surely prevent the leds from going nuts (not sure if they would to that if thicker ones were used, though! :smiley: )

Too bad you couldn’t fix those drivers again :zipper_mouth_face: Sometimes is delicate to have the wires changed, I’ve told you I’ve damaged some trying the same thing!
Sometimes is better to ask the maker to install the wires in a different way, specially if they are more expensive.

BTW, one or 2 suggestions in case you wanna try it. If you want something like and after glow, you can try the GITD gaskets or some GITD tape to put around the TIR.

Seeing that you’ll use Nichia, to avoid any green stuff, I’d suggest using orange GITD tape or orange GITD gasket.

These have green GITD tape (which sometimes shifts the beam tint):

These have GITD gaskets (made by CRX):

This adds an extra “bling” to your build, which is also useful in many cases :wink: