I ordered myself a P60 drop-in as a Christmas gift.
Anyone else do that? What did you get?
mt-g2 on a noctigon board and a qlite driver with all the bits to mod it to make it work and raise the current to around 4 amps.
… and a harbor freight aluminum racing jack. 
Brian
P25vn
Kryton Groove (Red & Black Marble and a Clear Ano) *clear not pictured since it sent out to get purple and black marble ano to match these two
C6 rainbow ano set (10 hosts in total)
520nm LaserBtb
The red/black groove is getting a 635nm dropping in it and I plan to build the C6 set into lasers and maybe put a few back to flashlights 
- ld12 g2
Dqg triple xpg2 26650
A samsung Note 3 :bigsmile:
DQG AA
Cyclone C88
Starry Night 4x AA
Klarus P2A ( ordered b4 all the rest—but still waiting 4 it from Wallbuys)
RMSEN RV-107 AAA
Int’l Outdoor –16340 Bullet Light
Eneloops AA & AAA
Must stop now……
Nexus 7 2nd Generation 32 Gb
qlites and 80+cri xmls
h600w mkii
quadrocopter
and possibly more things that I can’t remember not all made it in time
DELL XPS L702X 17.3” Laptop
HD2010 from TMart
Shipped out of NJ so no 3 month wait
Fenix BT20 bike light
Xtar SP2 charger
2 Eden 3400mAh 18650 batteries (= Panasonic cell)
New windows - the ones I have were put in in August 1936. About time for a change.
But given the winds here just now I may need new windows quite quickly.
I think I can pass the BTU Shocker as a Christmas present for myself. I’m not sure what I classify the other ~5 flashlights and pieces in the past months
I have some of those old windows. You can literally feel cold and light wind pass straight through them.
Wow you have a good memory Don. I cant remember what I did yesterday. 
Aluminium framed?
I’ve been naughty this year… gave myself a lump of coal… After that little run-in with the punji sticks in the fireplace a few years back, Santa doesn’t stop here any more. J)
Nothing yet. :_( Nice to read this thread for ideas though!
A HK 416, a red dot and an abgled foregrip : )
+1
Actually I did buy a 405 nm/700 mW/single mode laser diode/driver/nice lens. Got it mounted to a small desktop CNC mill and running at 1/2 watt. Just got it all running a couple hours ago. Using it to cut solder paste stencils.