You have my interest !
Proto done, pls check the 1st post.
It looks real nice! How long until the production model?
Looks great! Should be a winnerā¦.
Both models look very nice.
What size driver and emitter board will it take?
Nice one RayLight Brassy! :+1:
Iāll take it in copper if itās reasonably priced (like $50). No interest in Brass or Damascus for $500.
I like the brass prototype, would be interested in a copper versionā¦ The Damascus one has flat spots in the tube for logos but it could look out of place if thereās no engraving. I think a knurling or tube pattern will suit it better.
14.6mm driver, 10.5mm star.
The flat spots donāt look good on brass, but I think it will looks great with dama paterns.
First thought is 0.2-3-25-100 lumens on Nichia, but we just found that 0.2lm is barely noticeable. pictures below:
Those modes sound almost perfect, though Iād suggest making the two middle modes slightly higher. Like, 0.2 lm / 5 lm / 32 lm / 100 lm.
How bright was the room when those pictures were taken? A 0.2 lm mode is only for use in very very dark placesā¦ Itās fairly common, when someone turns on a light in moon mode during the day, that they wonāt realize itās on without pointing it at their face.
Thanks!
Iām always looking for nice small hosts which can be modded easily, and this sounds promising. 
outer size: 20.5*91mm (this might change)
How much are we talking about for the brass? Just a ballpark figure is good for nowā¦
interested
Approx 50$, shipped.
Looks promising.
Is there any plan for copper version?
Interesting. It looked smaller than that.
I have a couple brass 18650 lights which are about 20.5mm * 97mm, and some brass AA/14500 lights which are 17mm * 76mm. So, those are both possible. Theyāre not as detailed though, the body accents are shallower, the switches arenāt recessed (only flush), and they donāt have any diameter difference between head and body.
Iām interested!
The brass version looks nice. The 0.2-3-25-100 modes also work for me.