[WTT] FW3A FET+7+1 driver for FET+1 driver

4 posts / 0 new
Last post
antoninuspius
Offline
Last seen: 7 hours 11 min ago
Joined: 11/04/2018 - 19:22
Posts: 45
Location: Roma Antiqua
[WTT] FW3A FET+7+1 driver for FET+1 driver

I’m going to put a Lux-rc driver in my FW3T and I’ll be turning the original driver into a contact board. I’d feel bad doing this to one of the desirable (and apparently discontinued) FET+7+1 drivers that I have, so I would like to trade my FET+7+1 for one of the newer FET+1 drivers that I can destroy without feeling too bad. CONUS strongly preferred.

Scallywag
Scallywag's picture
Offline
Last seen: 18 hours 44 min ago
Joined: 01/11/2018 - 22:23
Posts: 2200
Location: Ohio, United States

This is actually something I’d recommend, since the new drivers also seem to be single-sided if I’m remembering right

SlaytheIncubus
Offline
Last seen: 1 week 1 day ago
Joined: 12/31/2019 - 23:35
Posts: 71
Location: Deep South

Would you be interested in an outright sell of the board? I can promise I’ll never butcher it.

__________

antoninuspius
Offline
Last seen: 7 hours 11 min ago
Joined: 11/04/2018 - 19:22
Posts: 45
Location: Roma Antiqua

Unfortunately no. I’m going to need some way to get the power and signal to the correct place on the Lux RC.