ENEDED

[djozz]

@SKV89

Isnt 3A too much for the Optisolis which Clemence said should be limited to 0.5A each emitter so we should be looking at 2A. I also wonder if the screw locations will fit the 21mm optisolis board. Freeme do you know the diameter of the pcb?

750mA per led is steep but my test shows that they can handle it, at least for a short while

I’m not going to use an Optisolis board but a 20mm XM-board, like I did with my S2+ with Optisolis.

Output and voltage test of 5000K and 3000K Nichia Optisolis leds

[image] [image] This an output and voltage test of the new ultra-high CRI Nichia Optisolis leds. Thanks to Clemence who was able to sell some very early samples of these leds for very little money. A discussion thread on these leds was here. This post is strange enough not about the most important aspects of the Optosolis leds: the tint, CRI and colour reproduction, simply because I do not have the equipment for measuring that. I hope that maukka at some point can do tests on tint and spectrum,…