UF-1504, 1503, 1505 - multiple LED's tested for throw (just what you have been waiting for!!!)

[luminarium_iaculator]

@djozz

@luminarium iaculator

Thanks :),

Does this mod have any influence on mode changing?(mode memory is still present?) and how it looks on lower modes like low and medium?

The lower modes look normal, and so does memory. I never checked the low voltage protection and reverse polarity protection, but I see no way how they should be affected by this mod (the board lay-out is effectively the same as Wight's board, which is directly derived from these NANJG boards).

A tip: glue the FET down, because being upside down it is only soldered on one side and the led-minus wire attached on the top could rip it off while fiddling to get the driver/pill/ledboard attached. I never glued it but the FET did tilt during this last build with the thick led wires.

Tip2 solder two legs from the Attiny together (or connect one of the stars to ground) to get rid of the blinkies.

Thank you very much Sir! You are one extraordinary man (you would not believe how much you helped me past two years...)

10xAK47 driver ordered from FT (although I have single mode AK 101/105's like drivers that are bit different from original nanjgs).

For glue advice I think I will use AA for FET and pot whole driver with Fujik.

Will try to run protected generic cells like samsung 2600 on this cause I don't need currents higher than 3A.

Your thread here is very educative.