wtf wont my bleeder resistor work?

[Lexel]

@JasonWW

@Lexel

try 1k bleeder and 10k led resistors, the higher the values the better chance it works

The leds are not very bright considering they use 330 ohm resistors. Switching to 10k might make them super dim. I was going to 3x to 6x their resistance first and see if it works without getting too dim.

This kind of stuff makes me want to use a trim pot on the leds.

rainbow lighted tail boards any color combinations possible, adjustable with 2 trimmers

Hi, First I tried it on my regular 6x Tail boards with conventional 6 Balance resistors and a 1kOhm Bleeder Main Problem was that with low battery voltage the higher voltage LEds (Blue, White, pink, ice blue) get dimmer tan the low voltage ones (red, yellow, green) [image] I came up to enhance this idea with a voltage regulator, but had to do some steps to make it work first get the voltage and resistor value for each LED at the same brightness [image] [image] Then I made some calculatio…

4. August 2018