Copper X6 heatsinks(CLOSED ORDER PAGE IS UP)

Flashlight Modding and DIY Parts
101

Can Dale or someone else confirm the lens size on the X6? I’ve heard the factory lens isn’t very good, so I’m going to order a UCL

102

The UCLp from flashlightlens.com is outstanding and fits perfectly.

103

Everyone that’s getting a Triple should give Hank at Intl-Outdoor a big Thank You as he had a second run of the 32mm Noctigons made so we could do this. Without these boards, these little bada$$es wouldn’t be happening.

Thanks Hank!

104

^^^^ Thanks Hank

105

Thanks so much, Hank!

106

Am I right that this would work?

http://intl-outdoor.com/noctigon-3xp-mcpcb-nichia-nvsl219bt-r85-d220-leds-p-797.html

or any of these?
LED Flashlight-INTL Outdoor Storesurface+mount+copper+jumpers&x=18&y=8

107

Those are all 20mm boards. For the Triple in this thread, THIS is the only one

108

gotcha. I can continue to hope, anyhow.

109

I think I read somewhere that someone contacted the seller and had them reflow some LED’s onto that board for a fee, but I can’t remember where I read that. You can try contacting Hank at intl-outdoor, or I’m sure Richard at mtn electronics would do it too

110

Any 20mm boards will work for the quad and the 32mm Noctigon XP32 will work on the triple

Hank if u need the LED's reflowed i can do it for a small fee ? just let me no the led and ill mail it out with your order ?

111

The 20mm mcpcb’s will work in the quad, but are the 20mm triple optics the same height and diameter as the quad’s are?

edit: The quad optics are 24mm at the top, and these triple optics are only 20mm, so you would have to add a spacer or something to get that to work (not sure why anyone would want to do that anyway)

112

yes i think u will need to make a spacer to make a 20mm optic work because the heatsink was designed for a 24mm optic

but if u want to use a 20mm optic u can use a washer(24mm) and just drill the inside hole out to 20mm ??

113

If the 20mm triple optics are the same height as the 24mm quad optics then either one should work since the mcpcb will center both.

114

correct my post above is to make it secure inside by using the washer BUT the glass lens should put pressure on it to hold into place

115

That was me, i asked Hank to reflow 3 XP-L V6 3D in the right set up for the triple optics build on the xp 32 noctigon, and he was very nice to do it for free.

Thanks Hank :slight_smile:

116

How much the cost if i want you to reflow it nitro?

117

just send me the LED's & board or the cost of having them ordered by me and sent to me and ill do it for nothing :)

118

put it on my tab :wink:

119

I actually had an XP-L not make contact in a reflow to a 20mm Noctigon yesterday. Put the light together (X6) and it wouldn’t work. I’ve re-flowed hundreds now and that hasn’t happened in forever!

Got in a hurry and didn’t let the plate heat up good. The smaller emitters don’t weigh enough to seat em down onto the star when the solder doesn’t flow quickly. And I’ve found that pushing them down can get them off center and cause a short between the thermal pad and connection with overflow under the emitter.

Just goes to show, with this game…it’s always something!

120

Could you put me down for 2 copper triple kits.