thanks for commenting
the tint seems less green than my Opple reports for a couple of reasons
- my Opple reads about 0.0025 high
- at almost 5000K positive DUV is less noticeable
- I mentioned that I was looking at the tint during a sunny day.. sunlight has a nominal duv of 0.0032 so it makes the positive duv of a 519a a close match to my daylight adapted brain.
I reserve the option to dedome the LED at some point in the future ![]()
I did set the floor to 1/150 and it still measured the 1.2 lm default of advanced smooth ramping.. so that is as low as the buck driver is going to get.
Waving the light vigorously does not produce dots at that floor level, so I can say with confidence that there is no visible flicker at floor.
And even though there is 73% Riple depth, the frequency is over 5000Hz, which is beyond the visible range.
I intentionally tested the Flicker Index on floor, as that is usually where the deepest Ripple, and highest Flicker Index will be found. But this is not a light that I intend to use at outputs below 10 lumens.
When I want sublumen I use my D3AA. But the little TS10V3 is a handy general use light around the house, such as looking in a dark closet during the day.. I have memory set to 30 lumens, which is generally effective for a lot of my indoor uses during the day.
The TS10 form factor is very convenient in cigar grip, and also as a mouth hold light for brief uses.
And it easily lights up things 50 feet away in my back yard, even with ceiling set to 100, which has the benefit of not getting hot..
basically this little light is a general use urban EDC light, for me. I dont consider it a hiking light, nor a nightstand light.. I have other options for those applications.
Otoh, the TS10SG is perfectly adequate for walking to and from my car or mailbox after dark, and bright enough to see along a sidewalk, in addition to my primary applications indoors.. I think it is a nice small pocket light for office use as well..